Post by nscaler711 on Mar 15, 2016 0:46:17 GMT -5
Ok so I managed to get a MTL coupler (903) into that pilot.
It wasn't too difficult, I just have to remember when I remove the shell to start at the back and pull the rear of the frame
Ok so I did add a MTL SD40-2 plow as well...
Which I did have to file the bottom of the plow flush with the lip...
Anyway, all I did was cut the box out of the pilot, filed the 903 lid a bit more square, and added strip styrene behind the steps to keep the coupler box level, and CA'd the 903 to that...
I also still have clearance between the truck and coupler box (I did file the nub off the box)
It wasn't too difficult, I just have to remember when I remove the shell to start at the back and pull the rear of the frame
Ok so I did add a MTL SD40-2 plow as well...
Which I did have to file the bottom of the plow flush with the lip...
Anyway, all I did was cut the box out of the pilot, filed the 903 lid a bit more square, and added strip styrene behind the steps to keep the coupler box level, and CA'd the 903 to that...
I also still have clearance between the truck and coupler box (I did file the nub off the box)
