|
Post by casey on Dec 9, 2020 15:02:12 GMT -5
Hi Guys been combing U.K E-Bay and come across quite a few Z gauge American outlines made by Marklin At About £75 on average how hard or easy would they be to convert and advice more than welcome thank you in advance Casey
|
|
|
Post by markm on Dec 10, 2020 13:09:44 GMT -5
There are some kits available for some for some Märklin models: www.zscalemonster.com/zelatory/The re no direct conversion as the Märklin bolster pin hold is larger than AZL or MTL. It's not too difficult to fill the ho;e and drill a new one for MTL trucks. Be aware ome of the rolling stock doesn't place the bolster hole in the prototypically correct location and you may need to drill the new hole in a new location. The MTL trucks provide the necessary information: www.micro-trains.com/index.php?route=product/category&path=75_117
|
|
mrz
New Member
Posts: 49
|
Post by mrz on Dec 10, 2020 14:12:22 GMT -5
Hi Casey, your quickest solution is to buy a transition car, Zscale monster sell these and they have a Marklin coupler one end and a knuckle coupler the other, well worth a look 👍
|
|