|
Post by ztrack on Aug 17, 2013 19:52:08 GMT -5
On Trainboard, there is an interesting thread concerning loads for AZL's centerbeams. I share the following on Trainboard today and thought I would post it here as well. I had some fun today. I was not completely satisfied with the art I was seeing online. I really wanted to use images of real lumber stacks for art. Much of the art seamed too clean and not real world enough. Yesterday, I took photos of wrapped lumber stacks at the loco 84 lumber. This particular 84 lumber has a siding for centerbeams. Below is one of my shots showing a stock of West Fraser kiln dried lumber: I took this photo into Photoshop and cleaned it up quite lot. I then used Quark Express to further turn the load into art. I created templates for AZL's 73' centerbeams. These templates will allow me to create loads quicker in the future. I added strapping to the art. The AZL 73' have 18 strap locations and these are all on the art. After lots of testing and tweaking I have the final load. Below is a quick iPhone photo. I plan to have a more thorough explanation of the process in an upcoming issue of Ztrack. We plan to include the art so folks can create their own loads. I have another lumber stack photo that I think will work for a 2nd load. I plan to keep an eye on 84 Lumber for more shipments. One note. The stacks I saw were plain white on top and the ends. The logos do not cover the top. I left the tops of my loads white with only the strapping showing. Rob
|
|
|
Post by ztrack on Aug 18, 2013 18:51:07 GMT -5
I had time today to knock out one more load. These loads are from Resolute. They were a bit more of challenge. The wrap has printed on lumber at the top. The finished art would have this lumber look splitting the loads. Also, I had to determine if I wanted to go five high or four high. The difference was 13 across versus 9 across. I tired the 5 high and the art was so small, you couldn't see the detail. The four hight has a much better look. Here is the prototype stack: Here is the car again take with a quick iPhone shot. Again, we will have a full article in Ztrack with art you can cut out and create your own loads. But this was one fun weekend project! Rob www.ztrack.com
|
|
|
Post by gyroflyer on Aug 18, 2013 21:23:08 GMT -5
Looks great. Now I have to buy some centerbeams.
Mark
|
|
|
Post by ztrack on Aug 19, 2013 21:34:58 GMT -5
Tonight we found our remaining stock of Stonebridge's 73' centerbeam truss loads. We have available triple fink trusses, hip girder trusses and parallel chord trusses. All are in the original packaging. The loads come 5 per side and are bundled together with wire. We are selling these in two packs so there is enough loads for each side of a car. We have a very limited stock of these. You can find them on Resale: www.ztrackresale.comRob
|
|