spoilybear
New Member
Hello all! New--Bee here to AZL , Getting ready for Christmass most loving time of year.
Posts: 42 
|
Post by spoilybear on Jun 27, 2018 11:50:07 GMT -5
Already removed body shell and Rear tail lens , need to know how to remove Cab glass so repaint shell . Any got way to best do it. Thanks Ben
|
|
|
|
Post by dazed on Jun 27, 2018 12:05:52 GMT -5
My experience is with an SD75I, and those are older than some of the SD70M's so they may have different methods. BUT, I'll post a few notes from my experience... 1. Best advice is take your time, be patient, be careful. 2. I used toothpicks to gently wedge and pry and coax. 3. I seem to recall that the front glass has to come out first. Or at least makes it easier. So the front windshield for sure. The hard part is the side windows. I just kept working them slowly, prying ever so carefully along the edges, and thinking it was never gonna come off....but then it did. 4. And BTW, the cab is a separate piece from the rest of the shell and does come off. That may or may not make it easier for you but I preferred it. Attachments:
|
|
spoilybear
New Member
Hello all! New--Bee here to AZL , Getting ready for Christmass most loving time of year.
Posts: 42
|
Post by spoilybear on Jun 27, 2018 13:57:12 GMT -5
Thanks Dazed , I did use thin Blade Razor Knife, thank AZ for Excellent type of engineering to make these , got it all apart did break small end off Center Light in back but should be easy repair with super glue. This is great sight for Questions when your green in couple areas. Thank you again . Ben
|
|
|
|
Post by dazed on Jun 27, 2018 14:32:12 GMT -5
I would not use superglue to repair...it will likely fog the clear lens.
Use "canopy cement" or any glue that states it is safe for clear parts.
And, you're welcome.
|
|
