|
Post by altunha on Nov 13, 2019 18:04:11 GMT -5
Has anyone developed a jig to easily remove Rokuhan connector pins? The Rokuhan tool that I purchased does not work 100% of the time, and it is frustrating.
Thanks
Jim
|
|
|
Post by zscalehobo on Nov 13, 2019 18:13:13 GMT -5
It works on the turnout connectors but NOT too well on the feeders. Put some back pressure on the pin where the wire is as you push the tube into place to ensure you get the tube seated around the "wings" of the spade pins. Then you can push with the L tool.
|
|
|
Post by altunha on Nov 13, 2019 19:59:24 GMT -5
Thank you Man! Getting those thingies out is next to impossible!
|
|
|
Post by arsenix2001 on Nov 19, 2019 18:07:11 GMT -5
Ive used a coffee stir/cocktail straw and cut a slit on the long axis to allow it to cave in on itself circularly and it seems to work pretty well.
|
|