|
Post by mgatdog on Aug 20, 2017 19:30:43 GMT -5
I've been running my new ES44 with 3 AZL well cars in the line up with no problem. Then I found 2 well cars that never had seen track time. So I put them behind the other 3. Now here is the problem. When the last 2 well cars cross a Rokuhan switch it throws Circuit breaker in the power pack. The cars are not dragging in the switch either. Has anyone had this problem since it's a metal car?
|
|
|
Post by davestubbs on Aug 20, 2017 20:12:49 GMT -5
Check and see if the etched metal parts at the end are close to touching the wheels. 2 little tabs that are just bent to hold the part on don't sit flat and cause problems. they can short the wheels and stop the truck from turning smoothly.
|
|
|
Post by davestubbs on Aug 20, 2017 20:22:04 GMT -5
this part, mine is silver some are yellow Tab under the car that hits the wheels just pull the inboard wheel off and try to bend tab as flat as you can.
|
|
|
Post by mgatdog on Aug 20, 2017 21:27:29 GMT -5
Thanks Dave I'll have to check that out tomorrow . I'll let you know.
|
|
|
Post by mgatdog on Aug 23, 2017 10:55:44 GMT -5
Well Dave checked it out didn't see anything to were it would hit the metal well car frames. So placed them back on track and ran them with no PowerPak circuit problems. Must been them darn Z scale track gremlins . 😖 Go fish.
|
|